How can I start using Priva Digital Services? (Building Automation)

To use the Priva Digital Services, the following actions need to be performed:

• Apply for a Priva Digital Services subscription via the order form on the Partner Support Portal
  
  
• Make ICT configurations to enable communication with the Priva Cloud
  Configure ports, FQDNs, and IP addresses.
  See ICT information (Building Automation)
  
  
• Configure and commission the project in TC Engineer / TC Select:
  See the Priva Digital Services manual that can be found on the Partner Support Portal.
  
  
• Install, register, and configure the Edge Gateway:
  The Edge Gateway enables secure communication between the building management system and the Priva Cloud. For each project, one Edge Gateway needs to be installed, registered, and configured.
  See the installation sheet of the Edge Gateway.
  
  
• Upload metadata to the cloud
  See Upload metadata to the cloud (Building Automation).
  
  
• Select the data points you want to store in Cloud History
  
  • Make sure you have the Access Control right 'Manage cloud history data points'.
  • In Building Operator: Select which data points you want to save in Cloud History (more info).
  The selected data points are now available in the Priva Digital Services so that the historical data can be used for, for example, creating reports, viewing historical alarms and viewing energy consumption. How far you can look back depends on your subscription.
  
  
• Get rights in Access Control
  See Explanation of user permissions in Priva Access Control (Building Automation)