Here you can compare the consumption between the buildings or building parts over a selected period.

Bar charts

* Are any of the above icons not displayed? This type of consumption may not apply to the selected building or is not configured in the Setup.

In the bar charts, you can either compare the total consumptions of the building (parts) or the consumptions per m² floor area (if the areas are entered in the setup).

Use interpolation for missing data: if there is any data missing (see Data validation), an estimate will be made for the missing data based on the data in other periods. Note that this is likely to be quite inaccurate. Especially when only a short period of data is available.

Table

In the table, you can compare the consumptions of the building (parts) over a certain period with the same period a year earlier.